Use a UDP source service to consume data from an application that sends messages over the UDP protocol. To create a UDP source service, use the UDP source service type.
You can configure the following properties for the UDP source service type:
Name of the UDP source service. Maximum length is 32 characters.
Description of the source service. Maximum length is 256 characters.
UDP port that the source application uses to connect to the EDS source service.
Maximum Event Size
Maximum length of data that the source service can read at a time, in bytes. Default is 8192. Minimum value is 1. Maximum value is 51200.
Retry on Failure
Indicates that the source service should try to open or read from the source if the operation fails the first time.
Number of Retries
The number of times the source service should retry to open or read from the source.
Delay between Retries
Time in milliseconds between successive retries.
Persist the data from the source locally so that the source service can continue to process data even if the target is not available.
You can configure the following persistence options:
. The batch size of the events in bytes after which the data is written to the persistent store. Specify a value of 0 if you want to write the data to the persistent store immediately. Default is 262144 bytes.
. The interval in milliseconds after which the source services writes data to the persistent store. Default is 5000 milliseconds.
. The maximum number of data files that the source service can keep in the persistent store. After the number of files exceed this number, a rollover occurs. Default is 10.
. The maximum size of each data file in bytes. When the file reaches the specified size, a file rollover occurs. Default is 1073741824.
. The maximum size of data that is unsent or has not received acknowledgment in bytes that can be stored in the persistent store. If the specified size is exceeded, the source service does not read data from the source. If you specify a value of 0, the unsent data can be as much as the value of
. Default is unlimited size.
The statistics that you can choose to monitor for the UDP source service. You can select the following statistics:
Bytes Sent. Number of bytes sent by the source service.
Events Sent. Number of events sent by the source service.
Events to be Sent. Number of events that the source service is yet to send.
Events not Delivered. Number of events that the source service did not deliver.
Send Rate (Per Sec). Number of bytes sent every second.