Table of Contents

Search

  1. Preface
  2. Introduction to Informatica Edge Data Streaming
  3. Licenses
  4. Using Informatica Administrator
  5. Creating and Managing the Edge Data Streaming Service
  6. Edge Data Streaming Entity Types
  7. Edge Data Streaming Nodes
  8. Data Connections
  9. Working With Data Flows
  10. Managing the Edge Data Streaming Components
  11. Security
  12. High Availability
  13. Disaster Recovery
  14. Monitoring Edge Data Streaming Entities
  15. Appendix A: Troubleshooting
  16. Appendix B: Frequently Asked Questions
  17. Appendix C: Regular Expressions
  18. Appendix D: Command Line Program
  19. Appendix E: Configuring Edge Data Streaming to Work With a ZooKeeper Observer
  20. Appendix F: Glossary

User Guide

User Guide

Configuring High Availability for Entities

Configuring High Availability for Entities

Configure high availability for an entity to ensure service continuity when the active entity goes down or you stop the node for administrative purposes. To configure high availability for an entity, start a
EDS Node
with the same name on two or more hosts. When you start a node with the same name on multiple hosts, the entity on one of the nodes becomes active. If you stop the node on which the active entity is running or if the primary node fails, the entity on one of the standby nodes becomes active.

Additional Configuration Tasks for Source Services

The following table describes additional tasks for configuring high availability for a particular type of source service:
Source Service Type
Additional Configuration Tasks
MQTT
No additional tasks.
Flat File, JSON
Configure the source application instances to log data to a file on a shared network drive and specify the shared location for the source service.
TCP
Configure the source application to connect to the new active node when fail over occurs.
Syslog
For information about how to set up high availability for a Syslog target service, contact Informatica Global Customer Support.
UDP
High availability is not supported.

Additional Configuration Tasks for Target Services

For some types of services, you might need to perform additional tasks to set up high availability.
The following table describes additional tasks for configuring high availability for a particular type of target service:
Target Service Type
Additional Configuration Tasks
Cassandra, PowerCenter, RulePoint
No additional tasks.
HDFS
Perform advanced configuration tasks for supporting high availability.

0 COMMENTS

We’d like to hear from you!